Discussion Locked

Dropped NetBios Sessions

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Greetings,

I have a perplexing problem occuring on my network. We have several servers
located at our co-lo vendor. We connect to them via a T-1 line. We can see these servers on our network as if they were local via static entries in our WINSand DNS servers here in the office. We can copy files from the NT 4.0 servers just fine. But when one user starts a copy from the Win2k server and another user starts a copy, the first user's copy is cancelled. The error message that the dialog gives is "Cannot Copy ex001101: The specified network name is no longer available."

We are using two routers for the T-1 line and a Linux firewall on this side of the T-1 line. I am of the opinion that none of these are causing this behavior since this only happens on the win2k server. But I'm open to suggestions for sure.

As I said, this only happens on the Win2k server. I have removed and re-
installed the TCP/IP stack but this fixed nothing. At this time my only
percieved recourse is to do a full re-install of the server, not a pleasant
thought.

any advice would be greatly appreciated!!

Rick Lamb
rickl@workz.com

5 replies

by duskos

There are several things you can try to eliminate causes of the problem.
1) Try to install Service Pack 1 for Win2000.
2) Try to copy using IP address of the Win2000 instead of Netbios name. This would eliminate NetBios problem.
3) Try to copy from two PC's on the same subnet as Win2000. This would eliminate or prove that the problem is with firewall and/or router.

by drdon

In addition to SP1 for Windows 2000 being applied, you can try one of two additional things, one is to map a drive to the NT server share you wish to copy to, and copy; the other is to setup and FTP session. Have found that FTP works much better over congested links to remote locations as well as mapped drives then just a connection to the server.

Look at the the WINS configuration one more time just to be sure. Then add the server and IP address to the LMHOSTS file on the Windows 2000 Server.

You should see an improvement in service.

Hope this helps

This discussion is closed to new replies.