14 replies
by jshoe85 Accepted solution
by tobif Accepted solution
by oh smeg Accepted solution
You would however have to enter the Devices Setup and make sure that the different Ways to connect to it are bridged.
Before buying I would look at the Instruction Manual for the device and see what it says in the Setup Side of things.
You can get the Instruction Manual from the Device Makers Web Site. ;)
http://homesupport.cisco.com/en-us/wireless/linksys/E3000
Col
by jshoe85 Accepted solution
by tobif Accepted solution
I had a look at the User Guide (http://homedownloads.cisco.com/downloads/userguide/1224655340631/Linksys_E3000_UG_USA_V10_NC-WEB.pdf) and from the information it is obvious that the router will happily transfer internal traffic forth and back between the two wireless networks.
How I can be so sure?
The unit has only one single setup for the internal IP network. All wifi clients will share one common ip subnet. I.e. as per specification, they should be able to talk directly to each other.
Further, I couldn't even find any possibility to split the two radio network into separate (routing) domains. (Guess that could be an interesting task for further development by vendor or very advanced users.)
by jshoe85 Accepted solution
by churdoo Accepted solution
This is more a question of IP than it is a question of wireless networks. I believe wireless is a layer 2 protocol, so as stated previously by Tobi and Smeg, if both nodes are in the same IP network, and you're not employing any particular functionality like wireless isolation or VLAN, etc. they will communicate.
--C
by robo_dev Accepted solution
As far as I know, most SOHO WLAN routers that support multiple SSIDs just dump them all into one network, as having multiple SSIDs allows you to run multiple authentication schemes all at once (e.g. WPA2, WEP, none) all based on SSID.
It's a handy way to connect devices that support different authentication methods.
For example, a Nintendo DS game console only supports WEP, but a Apple iPhone does WPA2, so both devices can connect by defining one SSID as the one for WEP and a different SSID to do WPA2.
Otherwise you would be forced to use WEP on the iPhone.
On many enterprise-class WLAN access points, you can allow multiple authentication types per SSID, but that can be very tricky to setup. By default, different SSIDs on these devices each go into a separate ethernet VLAN, but I digress...
by jshoe85 Accepted solution
by tobif Accepted solution
A typical G channel can theoretically carry 54 mbps. An N channel can carry more.
But these (advertised) speeds have to be shared between all participants. If your neighbor is using the same channels that you have, then the routers will agree on a "time share" basis.
If your neighbor uses an adjacent channel to yours, then reciprocal radio interference may force a fall-back to "A" channels or degrade your connection to almost nothing.
Other radio interference may also lead to lower capacity.
Even if we forget about radio interference from the outside: If you can put half of your computers on one frequency band, and half on another, then there will be less nodes that will share the available communication link on each frequency = higher speed.
by frank_s Accepted solution
by robo_dev Accepted solution
The wireless network side of the router is a mac-layer bridge.
This means it's all one network, so any protocols that can talk to each other will talk to each other.
by jshoe85 Accepted solution
by choppit Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending