Discussion Locked

Dual Boot Problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm trying to dual boot several computers (for the A+ class I teach). In some cases I was able to install WIN98SE and then WIN2000 Professional and in several others, WIN2000 complained that Drive C: was corrupted and could not be repaired.

I tried repartitioning and formatting with WIN2000 (FAT32) and then reformatting with 98. That worked in a couple of cases. In the cases where it didn't work, I was able to reinstall WIN98 but got the same result when trying to install WIN2000 Professional.

Does anyone know what could cause this? I'm going to try Partition Magic next, but does anyone know a way to do this with Windows utilities?

Thanks for any help.

5 replies

by dmiles

There are bad sectors being recognized on the hard drive in setup process.
You can try running scan disk and fixing the bad sectors whereas they will allocated as non-useable.
Using Partition Magic may be of help,but you may not get the dual boot setup to work,the drive may be going out and this causes reformatting problems,even if one operating system loads you will have problems when using scan disk and defragmenting,because the sectors will create an unable to read error message.

This discussion is closed to new replies.