11 replies
by mgonzales
Yes...just make sure that you only format the HD with Fat16 not FAT32. NT4.0 will not run on Fat32.
Good Luck!
by edgar.silva
To add to the above, if you want the Win98 OS to access files that are created/modified/used by NT you will need to use FAT16 not NTFS since Win98 cannot access NTFS drives either.
Hope that helps,
by edgar.silva
by timber
Ok the answers above are correct but I believe from the question you don't want to re-format your drive.
Hopefully your drive is fat 16 if not you have to fdisk it and start over. Install 95 or 98 first then install NT make sure when you installNT you select leave current file system.
If your drive is fat16, maybe when you installed NT initially you had the dos system files from the initial format. When you boot up does it give you an option to boot to DOS or do you only have Windows NT and Windows NT VGA Mode? If you have the DOS boot option select that on startup create an autoexec.bat and config.sys to load the appropriate cd drivers. Then install win98.
If you have WinNT only with no DOS system files your honestly better offto format the drive install 98 then install NT.
However if you really want to keep your existing config read up on the boot.ini (making the appropriate changes) Create a Emergency Repair Disk you will have to repair the boot sector so NT will boot again. It's a pain but it is possible there are a few decent articles on this but plan on one step being left out of every article. I have yet to read a perfect one.
Make sure you have a good backup of all important data before you try this....
Hope that helps....
by edgar.silva
by arwjnplanotx
The answer to your question is you can't. You must install Windows 98 on a clean 16 bit fat formated boot partition then install NT. The Windows 98 OS can reside on a fat 32 partition and NT OS can reside on an NTFS partition but they both must start on a fat 16 partition to work together. NT doesn't recognize fat 32 and 98 doesn't recognize NTFS partitions.
To enable dual boot Windows 98 must be installed first.
Hope this helps,
Al
by edgar.silva
by debisse
1. Repartition your disk with PQMagic(or another tool) for example resize the NT partition from 4 GB to 2 GB.
2. Create a primary partition with 2GB (the rest)
3. Install XFDISK (Boot manager shareware) with a Bootdisk and set the empty W98 partition as active.
4. Install W98
5. After W98 is installed, boot again from the bootdisk and rewrite the Bootmanager again
6. After that you can choose NT or 98 in the bootmanager Menue
XFDISK hides the non-active partition
If you need a data partition with access from NT and W98 you have to create
Primary NT
Primary W98
extended logical for Data
We made the solution with 3 Primarys (NT,W98,W95) and 1 extended >It works
The maximum is 4 Partitions including the extended
4 InstallW98
by edgar.silva
by edgar.silva
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending