9 replies
by justmeangie
by tbrewer
by it
Good starting point:
http://support.microsoft.com/support/kb/articles/Q148/9/25.ASP
Typically, I have found this to be a problem when the password file is corrupt. Microsoft can walk you through the process better than I, so I recommend lookingat the above page.
by tbrewer
by jovajo
This can occur if you are not currently logged on to Windows. If you click Cancel in the logon dialog box that appears when Windows is starting, your password cache list file is not opened, and your passwords cannot be saved.
This problem can also occur if you have installed Dial-Up Networking but the
client for Microsoft networks or the client for NetWare networks has not been
installed.
Solution
1. Remove your *.pwl file and when you start the computer type a new password.
2. Install the client for Microsoft networks or the client for NetWare networks
If these steps don't work:
Verify that password caching is enabled. Open the Registry Editor to
view the DisablePwdCaching DWORD value in the following registry key:HKEY_LOCAL_MACHINE\Software\Microsoft\Windows\CurrentVersion\Policies\Network
If password caching is disabled, the DisablePwdCaching DWORD value has a value
data of 1. To enable password caching, change the value data to "0" (without
the quotation).
NOTE: If the DisablePwdCaching value does not exist, add this DWORD value with
a data value of 0 to the registry key listed above. You may need to remove
this value altogether, and then restart your computer to make caching work
Regards
by tbrewer
by tslynge
You have to install the client program for Mocrosoft networking to make the box let you check. Go to control panel, network, add client, choose the microsoft networking client and You'll be able to save the DUN-password.
Best regards !
by tbrewer
by tbrewer
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending