Question Locked

DVD drives not showing up in CMOS

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

On a recent PC build I have installed a single SATA HD and two DVD
optical drives. Unfotunately, regardless of proper hardware
configuration, I can't see to get the optical drives to be recognized by
the CMOS. The two DVD drives are recognized upon boot up (by both
name and serial #), but once in CMOS there is no recognition of them as
IDE master and slave. I'm kinda stuck here, but at the same time I really
want to understand and learn from this snag. Any info. would be
greatly, greatly apprerciated. Thanks.

-Eager to Learn

4 replies

by hal 9000

In BIOS you will only see the Physical size of a drive so you can see the size of any HDD but as Optical Drives have no Physical Size they don't appear in the BIOS.

Provided that you can see then on Boot up things are working correctly.

Col

by jameson131

Thank you so much, you've become my online Prof...

If the optical drives aren't showing up in the CMOS, how
can I set them to be booted to first so I can load my OS?
Everything else seems to be falling in place logically (ram,
vid card, audio card etc...) but I seem to be running head
first into a wall with the optical drives...I can give any
hardware details neccessary. Sorry for being a stickler,
just trying to be thorough. I'm really here to absorb as
much knowledge from pros as I possibly can. Thanks!!

by hal 9000

With either the Makers Name or M'Board Makers Name on it turn this off in BIOS and then restart the system. After the Memory test is performed the system should go through the available Drives which means it should show the IDE Drives that are available at this stage you can press the Pause Key [i]unless you have a USB Keyboard in which case it will not be working[/i] on the Keyboard and look at what is being shown.

If there are no DVD Drives shown you have most likely failed to set the jumpers correctly with one to Master and the other to Slave. As you can not have 2 Master Drives on the one IDE Lead. The Jumper is beside the IDE Cable away from the Power Lead side and the jumpers depending on the make of the drives are normally a green colour. There are 3 rows of 2 pins one is Master another is Cable Select and the third row of pins is Slave. This will be shown on the metal part of the case and generally has the Master closest to the IDE Lead then CS and then Slave though this may vary between different makes.

PM me if you have any problems getting this to work.

Col

This discussion is closed to new replies.