Discussion Locked

DVD software freeze

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Customer is experiencing a partial freeze when attempting to run DVD movies using ATI Xpert 98 8 MB video and ATI V. 3.1 DVD player software.

Computer is AMD K6-3 450/128 MB RAM using Creative 5X Encore DVD hardware and exceeds all requirements for playing.

I have formatted disk with clean install of Win 98 SE and computer experiences partial freeze, movie freezes but mouse cursor movement still there although it doesn't do anything other than move.

This occurs randomly from near thebeginning of the movie through the first half hour.

There are no error messages and Ctrl+Alt+Del is not available.

I don't do a lot with DVD and am not stumped. Have now waited several days for response from ATI with nothing back so far.Any suggestions?

Thanks in advance.

John

9 replies

by tabor

You may want to check the refresh rate of the adapter. If it is set to Optimal or Adapter default, manually change it to 75Hz, if your monitor and adapter will accept it. Had the same case with my DVD and this did the job.

by compute2u

I would guess that the customer has a C Drive(one Harddrive) and the DVD? If this is the case then it is because of the ide bus. The ide bus can't read and write at the same time and the DVD is using the Swap file in windows to buffer info. You can add a whole bunch of ram or better yet, put the DVD-rom on the second ide bus.

by iracox

Hello,
You might want to make sure that "Use DMA" is not checked in the settings of the CD ROM ( Start, Settings,Control Panel,System, Device Manager,Double click on CD ROM,Double click on Creative DVD ROM, and then Settings). Also Make sure that the right drivers are used for the decoder card ie; (Dxr2,Dxr3).I hope this helps.

This discussion is closed to new replies.