Discussion Locked

Emergency Repair Process not working

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I came in one morning and my server was showing a stack dump.
I got as far as the identification of starage devices in the Emergency repair process. Then, the stack dump information appeared again.

Any ideas?
Thanks

11 replies

by syscokid

I'd say it's almost definitely a hardware problem. BSOD is almost always a hardware problem. I would run a diagnostics program like QAPlus or whatever's your favorite to pinpoint the cause of the problem.

by spydergst1

The first answer is right. More then likely this is a problem with RAM. Pull all the ram and put one ram chip at a time. reboot after each chip to find the bad ram chip. If ram is not the problem follow the same procedure with the processors. remember to keep in mind if you are running a single processor kernal or a multi-processor kernal.

by avadhani

Yes what the above fellas are saying is correct.I my self sufferd this stack dump problem at least in two locations I am giving support. The culprits in the order of priority are
your HDD
then RAM

by ramy naguib

at NT boot press F6 and then re-install the right driver for your SCSI card or Raid controller ,and that should solve the problem.
Thanks
Ramy Naguib

by bruski2k

I had this prob with Win2k Pro (SP1) couple months ago and it was a defective HDD.

Ran Maxtor's MaxDiag and got read errors, it gave me a code to give to Maxtors Techs, they replaced drive in 2 days without hassles.

Both Maxtor and Western Digital have excellent IDE drive diagnostic programs avail for free download from their respective sites.

Hope this helps
Bruce

This discussion is closed to new replies.