Discussion Locked

Emergency start disk, boot disk?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

What is the difference between an emergency start disk, a recovery disk and a boot disk?

Do I need all three? How do I create them?

6 replies

by lo

Susan

Before you act on this, let someone blow holes in my response. Doing this partly to see if I am right. I assume you are refering to Win 98 for your OS (Win NT has same / similar, most likely Linux also but by other names).

Emergency Start Disk - This disk is created after a successful Operating System (OS) install. It has boot files and drivers that match the hardware on your system. It should also be created whenever you add or remove hardware.

Recoverey Disk - I think this is the same as above. Windows refers to this as an ERD, Emergency Reepair Disk.

Boot Disk - this is any disk that has enough of an OS that it can boot. Enough consists of 3-4 hidden files + the OS (for dos based this is IO.SYS, MSDOS.SYS and COMMAND.COM (may be some I missed)). For Win 98 it is same/simiar + drivers for devices. The ERD is will boot. If a disk (hard or floppy) isn't a boot disk you get a 'non-system disk' error.

I forget the details of creating (don't do a lot and have to lookup each time). Do Start, Help, Find and search for Repair Disk or Emergency Repair Disk. When you find out how, if you haven't done one or haven't done one in a while, create one. Takes 1 or 2 FD (I think it formats before it copies, but I like to use blank, formatted diskettes).

lo

by avachon

Hi, the first respondent is on track:
Much depends on the operating system:
For 9.x: start disk and boot disk are the same thing. They are used to start or boot the machine when some problem is keeping it from doing so (e.g., configuration problem). You could, for example, use a boot disk on a 98 or 95 machine to either boot into the OS or get to the screen where the logo begins and press f8 to get into an option menu (and one option is start in safe mode). You can make a 9.x boot disk by going into control panel | add/remove programs, click on 2nd tab to create the disk. On NT, a boot disk, again, is used to boot the machine if some configuration problem is keeping it from booting properly (you'd copy the files ntldr, boot.ini, ntdetect.com, ntbootdd.sys if you have a scsi drive with bios not enabled. These files are hidden so enable viewing them in explorer via options. An ERD (emergency repair) is done for nt by typing into the command prompt rdisk - this will allow you to "repair" a corrupt nt configuration (or try to). rdisk /s copies configuration info. regarding the SAM database on nt. You should have a boot disk for each OS and an updated ERD for NT. Hope this helps.

by avachon

Hi, just an added note - when creating an ERD, it must be specific to that machine. You cannot create a "general" ERD that could be used on all nt machines. Finally, if for some reason you cannot create a boot disk for a machine, or something happpens to it before you get around to creating the boot disk, you always can take a look at http://www.bootdisk.com You can download a zipped boot disk off the web onto a working machine, create your boot disk, and then tackle repairing the failing machine.

This discussion is closed to new replies.