Discussion Locked

error code

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
When ever I boot up a win98 client while it's going through it's post. I get an error message as follows:
error 0271: Check date and time settings
Press F1 to continue or F2 to go into time settings. I press f1 to continue and everythingseems to be running fine.But this message appears everytime when I boot up the win98 machine . Can anybody explain what this means and how to fix it..Any help would be appreciated. Thank's in advance...

11 replies

by gjones

I sounds like the system time in the BIOS doesn't correspond with the time in Windows.
1. Set the correct time in the bios save the settings and exit.

2. Set the time in windows double click on the clock. (check that it is set for the correct time zone).

you use the arrow keys and tab to move about in the bios.

by searogue

Hi, if the previous answer doesn't fix it, try checking / changing your system battery.

HTH

Bets Regards,

Tony

by paul majestic

If replacing you CMOS battey doesn't work then the problem might lay in the motherboard itself. You might want to try updating the BIOS. I have seen this correct the problem before.

by fyrebat

Hi there,

Most people have like a silver watch battary that keeps the system time and date, when these errors happen, the battery is 80% of this problem, what I suggest doing is checking on the board what kind of battery u need and goto a place like radio shack where they usually keep a pretty good stock.

After replacing the battery, reboot the computer into DOS mode and run the TIME command and reset the system time and date.

by fyrebat

Hi there,

Most people have like a silver watch battary that keeps the system time and date, when these errors happen, the battery is 80% of this problem, what I suggest doing is checking on the board what kind of battery u need and goto a place like radio shack where they usually keep a pretty good stock.

After replacing the battery, reboot the computer into DOS mode and run the TIME command and reset the system time and date.

This discussion is closed to new replies.