Discussion Locked

Event ID ---9

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an account that runs NT with approx 25 98 clients. The new server was just installed. It uses 3 SCSI HDs in a raid array. The scsi adapter is on the MB with an adaptec 1130 for the array. There is also an HP scsi tape on the other scsi bus onthe MB.There is a cdrom drive on the ide bus. It is the only thing on the ide bus.
From time to time the system locks up and I can hear the cd rom making noise like it is looking for a cd. I then get the event id 9 postyed in the event log. Does anyone have any ideas? I just replaced the CD to satisfy the customer but of course it was not the problem. Is there any where I can get more information on event numbers than I get from the system or the resource kit??

4 replies

by syscokid

Found this at http://support.microsoft.com/support/kb/articles/Q259/2/37.ASP

Event ID 9 indicates that an I/O time-out has occurred within the storage system, as detected from the driver for the controller. This time-out does not involve the cluster software in any way. The I/O request made to the device was not completed within a reasonable amount of time. When the I/O request expires (times out), the driver resets the SCSI bus. Although this could indicate other problems, this could also be caused in some configurations by powering on or off devices on the shared bus, if the bus is differential. Time-out events could indicate cabling, termination, or SCSI hardware configuration problems.

General Troubleshooting
Use the following general troubleshooting methods to help resolve event ID 9
Check for loose connections.

Check for physical damage to cables or connector pins.

Make sure that the driver and firmware versions match those used on all servers in the cluster.
Check with the manufacturer for updates.

For SCSI-based storage:
Make sure that you have a "Y" cable with an external physical terminator.

(The entire articlie is too big to post here. Follow the link above.)

For additional information, click the article number below to view the article in the Microsoft Knowledge Base:
Q154690 How to Troubleshoot Event 9 and Event 11 Error Messages
Q182335 INFO: Format of Event Log Data Created by ScsiPortLogError

by syscokid

(Sometimes when I cut and paste URL's it looks ok to me but once the answer is posted, an extraneous space will have crept in. Make sure you delete any extraneous spaces or the page won't load).

by wcr

Sorry to be so late getting back. This looks like it is the right direction to go when I get the system back to work on. Thanks

This discussion is closed to new replies.