Discussion Locked

Exception Error on Start of win 98

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I start Win 98 SE I get the following error messager:
An Exception 0E has occured at 0028:C0003E25 in VXD VMM(01) 00002E25. This was called from 0028:C000353F in VXD VMM(01) 0000253F.

The PC boots OK into Safe Mode but when trying to boot into Normal Mode I get the above message. Any help with this would be welcome.

5 replies

by dmiles

The (01) indicates a memory error which could mean that memory is accessing hardware
that is not 32bit,or that you have mismatched or bad memory,uninstall and reinstall memory one stick at a time and see if this will help.

by teds

Even though the problem indicated memory, it was only resolved by a re-install of Win 98

by robert_a_mocarski

The problem could be a driver or program that runs or loads when you start the computer. Did the problem begin when a new piece of hardware or software was installed?

Try booting into windows while holding the shift key down. This will keep some programs from starting when windows starts. If the problem does not reoccur, you will have to then figure out which program is causing the problem.

Win98 also comes with a utility called msconfig. You can go into the various tabs and turn off things from starting. The nice part about msconfig is that when you disable things, they remain in the list and you can reenable them merely by rechecking the box. Try disabling everything. If the problem goes away, you know it's software related. Then enable things one by one until you figure out what is causing the problem.

by teds

Using msconfig helped in finding the cause of the problem. It was a driver that had become corrupt. But I could not identify which one. A re-install of the OS cured the problem

This discussion is closed to new replies.