Discussion Locked

Exchange 5.5 & ISP/POP provider

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a client that has a Win 2000 server running Exchange 5.5 SP3. Internally within the LAN and the SMTP, outgoing email is working fine. My Question is, what do I have to do to get the external POP incoming service to work properly? They havea Cisco 678 dsl router for the service.

7 replies

by mckaytech

As far as I know, the only way to have Exchange download the mail from a POP3 server is to have the Small Business Server version with the POP3 Connector installed.

All versions of Exchange will act as a POP3 server and allow people to connect via a POP3 client, but only the SBS version will allow the Exchange server to act as a POP3 client.

What you will need to do is have your ISP set your mail up to be relayed to your server via SMTP. That configuration is fully supported.

paul

by duskos

To enable POP3 and SMTP in Exchange 5.5 you should install Internet Mail Connector (IMC) which is not installed by default with Exchange 5.5. I suppose you already did that.
Some clarification first:
SMTP is used to send mail.
POP 3 is used to download mail from mail server.
The problem with Exchange 5.5 and Windows 2000 is that Win 2000 uses its own SMTP service and the two usually cannot coexist. You should not run Exchange 5.5 on Win2000 which is configured as Domain Controller (because of SMTP and LDAP services). If you do, you should either disable SMTP service in Win 2000 or configure one service to use different port.
Other things to check is:
1. Do you use firewall? If you do, check that it is configured to allow ports 25 forSMTP and 110 for POP3.

2. Check that your Internet router is configured to allow traffic thru same ports.

by shmaltz

There is no such thing as POP incoming service. Incoming mail always goes with SMTP. If your problem is however that you now have a pop account hosted by your ISP and you want to be able to download thru pop access to your exchange server all the incoming mail then: As answer one pointed out microsoft supports this only for Small Buisness Server. However there are third party software you can use to accomplish this, one such software is from PopBeamer http://www.popbeamer.com.
If your problem is that incoming mail is working fine you just cant get your users to connect thru pop, then: you will have to enable (under protocols in the exchange adiministrator) the pop protocol, and make sure that the mailbox you are trying to access with pop is pop enabled.

This discussion is closed to new replies.