Question Locked

External USB Enclosure Fried My Drives

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had all my data backed up on 2 hard drives.
I was switching from a desktop to notebook/desktop replacement.
I attached the drives to an external USB enclosure.
Both were not recognized as USB by WIN XP.
I then tried the drives in a working computer and both cannot be seen by the BIOS.
I am pretty sure the USB enclosure/cable or its power supply fried the drives IDE.
I think that replacing the drive electronics board will get my drives working so that I can rettive my data.

3 replies

by dumphrey

be as simple as changing the master/slave/CS jumper on the hard drive. I had a disk that had to have no jumper when in the USB enclosure, but would work fine in CS position when it was the only drive on the IDE controller.

by mike2859

Enclosure specs drive jumper ed as master.
Tried drive in PC as slave and as master all not recognized at Bios level.
Thank you for the kind reply.

This discussion is closed to new replies.