Discussion Locked

Failed to load RASAPI32.DLL ERROR

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I installed earthlink toward the end of the installation this error message appeared on my screen, failed to load rasapi32.dll fatal error. Please tell me how to correct this so that I can get on to the net.

1 reply

by dmiles

You did not mention what operating system you are using,so go to Start>Settings>Control Panel-double-click the Add/Remove Programs,select the Windows Set-Up tab,click on communications and then uncheck the dial-up Networking box,click OK and reboot computer,repeat the process and put check in box next to dial- up networking If this does not work you can reference Microsoft knowledge base articles Q174579 and Q129605

This discussion is closed to new replies.