Discussion Locked

Fcchip intel 633 mhz cel. Pcchips754lmr

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed an intel flipchip 633mhz processor on a Pcchips m754lmr mainboard(which was not listed by the manufacturer).It appears to be working fine .However the chip uses a split pane vcore voltage .The manufacturer will not reply to whether the chip can be used on the motherboard .I feel I should reduce the vcc voltage to the chip .Can this be done?

2 replies

by dmiles

First refer to your chip and motherboard manual to researcd the vcc voltage specifications for the chip,it would be difficult to do without documentation and guessing could cause you problems.
The process of changing the voltage requires that you reset the jumpers on the motherboard.
Check the web for motherboard manuals before proceeding.
Logic if not broken donot fix it.

by davidahc

To Soulrider;I have researched chip with Intel who were most helpful , unlike Pcchips who did not answer . My updated amibios recognises the chip and does not allow me to change any voltage including the Vcc which is set too high.(neither does the motherboard).I am hoping someone has a similar combination .

This discussion is closed to new replies.