Discussion Locked

FDD not accessible

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm not able to access my floppy drive...error says drive not accessible pls chk I/O port...I checked I/O port settings but I don't know how to change it and what to put into it...using NT as my Operating System. Floppy and cable are good...

7 replies

by vertex

When I encounter this type of error message,
usually it meant a few things, first check
that no foreign object ( usually the floopy
tab ) is found inside the FDD. Next use a
floppy cleaner and clean the drive. Lastly,
replaced the FDD if all else fail. The fourth
factor would be with the floppy itself. Test
the FDD with other floppies first before you
do the self test above. Good luck.

by flan

you probably don't want to make changes in the BIOS, if you did, reload defaults for that particular device. and check if it works in dos. boot to floppy. if that doesn't work then you've got a bad floppy. you also might wanna check that you didn'tput the ide cable in backwards.

by c_saso

First to find out if this is a hardware or software issue. Reseat the cables on your floppy drive and try to use a boot disk (ex. Win95 or Win98 startup disk will work fine.) If able to boot from floppy then drive is good, if not then will need to replace drive.

Thank you

This discussion is closed to new replies.