Discussion Locked

FIC AZ11E On Board Sound

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have put together a system for home use. An FIC AZ11E board, Duron 750, ATI Expert 128 and Kingston NIC. When I installed Win2K, all the hardware was found, including the onboard modem and AC97 sound. Only problem is that there is no sound, noteven directly off the cdrom drive. I downloaded the latest drivers and I have gone through the Bios to make sure the sound system was enabled. I realize that I have missed something, but what is it?

10 replies

by jdoyon

I know that this might seem a little on the obvious side, but are you sure that your speakers are plugged into the correct jack? Sometimes, there is a line out as well as a speaker jack. Also, you may want to check your device manager, to see if youhave a resource conflict. This seems likely.

by csmith

Sometimes the most obvious is the easiest to overlook.
Example: At one customer, we were very pressed for time. In an upgrade we had to change the sound card. A coworker turned off the speakers and unplugged them while I was moving the Monitor. I opened the case, he went and got the card. Changed card and assembled. When he was plugging the speakers back in, he was distracted to another job by the client. He did not get to turn the speakers back on.
When I loaded the drivers for the new soundcard, no sound!
It took me a few minuites to notice that one. (The switch was on the back of the speaker.)
In other words start with the really simple stuff. (Check the volume control, try other speakers, etc.)
(Also if the speaker amp is bad, orthe batteries or PS are dead, try to set the speakers to direct. ie. most speakers will go to direct when the amp is turned off.)
Regards, Chris

by csmith

I had two calls on Gigabyte boards with AC97.
Would not work with Win2K or WinME. The did work with WIN98.
I am suspicious that there is a bug in the driver.
Regards, Chris

by zaphodtwin

I think the problem in IRQs that are not distributed properly between NIC & on-board sound - check it with Device Manager and try to separate these devices or try to change jumpers on NIC if possible. Usually sound takes IRQ 5, so you have to changeIRQ for your NIC to any else (except mandatory/optional for use by system):
1 - for KBD,
2 - aux IRQ controller,
3/4 for COMs,
6 - for FDD,
8 - CMOS/clock,
12 - PS/2 mouse,
13 - FPU,
14/15 - IDE controllers.
So, use for NIC 10/11, and for SB - 5!!!

Good Luck!!!

by fatherfox

Ok, start simple, first try rotating the cdrom cable at the soundcard or the cdrom 180 degrees unless it has a key to keep you from plugging it in incorrectly as a check. Next change the irq/dma combinations. Start with the sound chips recomendations unless it matches the default under windows. Next, if the newer drivers don't work, try an older one. If that or any other thread here doesn't work, do what I tell ALL on board sound runners to do. Get a soundcard. Not what you want to hear, I know, but unless it's a resource or driver problem, onboard sound is a nightmare and never gets fixed if it's broken for any reason.

This discussion is closed to new replies.