Discussion Locked

Fire wire (1394A) pin config. reversed?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

OK, I have a single firewire connection slot in the front of my
new case, I have 2 IEEE 1394A connections on my my MB (ECS
L4S5MG). I also have as luck would have it in my parts drawer
single firewire IO with 9 pin connection, IEEE 1394 is stamped on
the cable. Unnexpected bonus except that th pin assignment is
reversed. I have done a bunch of research and can't come up
with any fire wire revisions that included a pin reversal, anyone
know whats going on? Is this possibly a proprietary cable? Mac?
Can I rewire the connection assuming it is an exact reversal?

Well I doubt I'll get much response on this as the problem could
be resolved for 20 dollars, I'm just cheap, and I don't like it when
pins mess with me.

3 replies

by thechas

Well, I share your thriftiness.

I have seen numerous different pin-outs for both USB and PS/2 headers on motherboards, so why should we expect a common "standard" pin-out for fire-wire.

If you are careful, you can move the pins around on most connectors.

First, verify the pin-out for the motherboard header, and make sure that the pins go to the corresponding pins on the fire-wire end.

Depending on the construction of the connector, I use one of several different tools to release the catch for the pins.
For most header connectors, I use a pocket scribe.
Inspect the header closely.
Either carefully press down the metal flag on the pin, or pry up the plastic catch, and remove the pin and wire.
Do NOT press or pull to hard or far as it is VERY easy to damage a pin or the connector block.

Triple check the pin-out, and insert the leads into the correct position for your motherboard.

Chas

This discussion is closed to new replies.