Hardware

Ask something
Discussion Locked

fixing an emc clariion

0 helpful
2 replies

by theroyala9

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have an emc clariion. a base and a second
storage array. i believe it is the ip4700
(similar to the fc4700). i have attached the
upper half to a unisys es504151 w/ qlogic
isp2200. i have 15 spindles in all leaving five
in bottom half. the fc interface on the bottom
has only out<-> port. the interfaces for top and
bottom are different sizes and are keyed
differently, so the only way in<-> is through the
backplane. is there a "solution" to provide the
interface in this way?

2 replies

by oz_media

NOt to be a d&&l or anything here, but you have a definite issue that needs someof TR's best advice (there's some really top notch techs here).

You have allocated 3 points to your question, you will not likely attract TOO much attention even though points have been really deemed irrelevant these days. The thing is, YOU will be awarded 1000 points when you accept an answer and close the question. Top points holders have several hundred thousand and the most common value is a default of 150.

So you might want to add a higher value to your question. If you don't HAVE any points at all, you can always just reject MY reply and close the question. THEN you will have 1000 points and can offer it by posting again with 100 points awarded to it!

Unfortunately I don't have any valid ideas myself for you to try, I am sorry for just commenting on the points value but it SHOULD help if you boost it a bit.

Best of luck,
OM

by oz_media

LOL THAT didn't work at all did it?

Unfortunately there is no edit feature here, but 'd&&l' should have read d**k (if you know what I mean).

This discussion is closed to new replies.