2 replies
by negilum
Hi,
If the controler is bult into the mother board then you can try removing all the cards from the daughter slots (save the video) and see if it works. Also if it worked before and have changed your video card, put the old one back if possible.Lastly... long shot... try removing the ribbon from the harddrive and try it... I have had some harddrive brands screw up video and floppy controlers before... but thats rare!!! Good luck.
by admin
I keep a generic ide controller card on the bench. Pull all cards except the video with onboard controller connected as above. If it works, great, if not put the ide controller in one of the slots, disable the onboard one in the bios, swap the floppy ribbon from the main board to the ide card floppy pins and if it works it's in the board, if not, it's still in the floppy drive or the ribbon, most likely. You could of just got a new, yet bad ribbon or something, this will make sure the ribbon and floppy are good.
You could try reflashing the BIOS, but if it's definately the onboard controller with the problem, IMHE, it's usually hardware. In this case you can set up the controller card to remain, and get it up and running while you write the P.O. for a new ide controller card. Hope this helps!
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending