(No, I'm not sure how it happened, but I posted the two other "transient" answers above.)Without having too much to go on, It sounds like you've overlooked your BIOS settings. Different BIOSes are different, but they all have similar seting options.Make sure you run the "auto detect" in your BIOS for ALL the possible IDE devices. If your CD-ROM is indeed listed as "E-Drive", and assuming that you really have only one hard drive - or one partition on your hard drive - (and assuming you didn't assign that E-drive letter with NT) there are either two other IDE devices installed or the BIOS is set to incorrectly recognize them. My guess is that this "new" motherboard may be new to your computer, but has been installed on another computer before, thus the BIOS settings may by erroneous. If running the auto-detect doesn't help, you may want to try to revert your BIOS to its "default" or "factory settings". This will put everything back to the original (and more normal) settings. You might also want to try connecting your hard drive as your primary master, and your CD-Rom drive as the primary slave (instead of a secondary master or secondary slave.)
As for the floppy problem, again, make sure that the BIOS recognizes your floppy disk drive. If it doesn't recognize the drive, it's simply connected incorrectly, or it is bad. (Is the red edge of the ribbon cable attached to pin number one? This is most likely the pin closest to the drive power plug.) If the BIOS does recognize thedrive - and you're certain that the drive is installed correctly, you may have a bad floppy disk drive.
Good luck.
jr