Discussion Locked

Fresh install Win2k Srvr using upgrade

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I currently run a small (5 node) NT4.0 network on a very old machine and have purchased a new computer and Win2k Server upgrade. The old machine can't be upgraded to Win2k so I would like to install (fresh) Win2k Server on the new machine, set it up without upgrading any information from the old computer and once up and running just replace the old machine (taking it out of commission perminently). I followed Microsofts instruction in creating setup boot disks form my Win2k CD but they don't work nor does booting from the Win2k CD. Any suggestions on how to fresh install my Win2k Server upgrade on my new server?

7 replies

by dmiles

The first problem is that you have a W2K server upgrade that is not detecting the previous version of NT4 on the new machine,you cannot perform a upgrade to the new machine,because the upgrade uses the install files from the previous OS,which leavesthe previous files intact.
Cannot see the scenario working without installing NT on the new machine and then upgrading to W2K

by jmoylan

I tried that but the NT4.0 install won't recognize the hardware in the new computer (e.g. hard drive, etc). I'm sure I can load the new drivers needed but the whole idea of first installing NT to be able to install W2K seems a hassle and waste of time. Sureley there has to be another way.

by dmiles

Preview the users manul that came with the software and it will state that you have a upgrade version,my understanding is that you can only use it upgrade the previous OS.

by garoe48

Try booting from the floppies while the NT 4 cd is in the drive. The floppies should detect a valid NT 4 and then ask for the 2K cd.

Best, Glenn

This discussion is closed to new replies.