Discussion Locked

FTDisk

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently had to rplace a disk in a mirrored set. now everytime I reboot I get an error message in event viewer that has event ID 14 and says "The FT set containing \device\missingmirror3Member0 cannot be used" and Event ID12 which says "A stripe set or volume set member listed in the configuration information was missing". Before I replaced the bad HD I broke the mirror and after installing the new HD I created a new Mirror.
The new mirror set seems to be working OK but I would like to eliminate this error message.

7 replies

by avachon

Hi, just a couple of thoughts. . .did you go back into disk administrator and change drive letters so they matched the original configuration? (may have issues with shortcuts, etc.). Did you reapply your service pack after you created the new mirror? Hope these suggestions help.

by tmoran

Yeah, I set it up exactly as the previous installation had been set up. Sp6a has been re-applied.

by james_randy

If you are still tackling this problem, perhaps you should consider calling your local super-hero.

This discussion is closed to new replies.