Discussion Locked

Gateways

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I set up a gateway for a remote dial-up user from my NT server (PDC) to access my DSL internet line on my Proxy Server(BDC)?

8 replies

by juandemarco

This is quite easy actuly. Go to the Network Properties. Under TCP/IP, click on the last tab, and click the bix that says enable ip routing. If this box is grayed out, just install the MS Loopback adapter and then you will be able to check it. You can afterwerds un-install the loopback adapter. Make sure that all the gateway setting are setup correctly, and have the RAS settings for the dialup adapter set to DHCP assigned IP addresses, or assing them to use the DSL router (or the server's address if you are useing the server as the DSL router) as the default gateway. Reboot. That's all folks.
-Juan
P.S.-if you have any questions on this, just let me know, I've set this up menny times.

by juandemarco

Oh, ya. Proxy server. If you wish to go through the proxy server, you can just set up IE for it to automaticly detect proxy settings and give it the addr. of the proxy server. Netscape, you can make a new user and specify that you want the new profile (in netscape, not windows) for it to use the proxy server. When they dial in, they need to make sure that they use this profile. IE may need to be changed if they don't want to dial in to your network just to use the internet, depending on the IE ver.

by estebandelatorre

You have to point your default gateway to the BDC nic card adress, and in the BDC check the enable IP routing.
The enable ip routing will allow both interfaces to comunicate (the nic with the dsl interface)

This discussion is closed to new replies.