7 replies
by rcc
Disk or some media descriptor could be damaged.
Identify what brand and model the HDD is. Go to the manufacturer's website and look for repair/recovery/management tools. Get the tools on a floppy (bootable), boot of it, run the tools, run a low-level formating, than try to partition ans install an OS again.
Regards,
Radu
by otiss
by csmith
You did not say which brand of Hard Disk, but no problem.
Go to the manufacturers website and download the diagnostic and setup disks.
Zero Fill or Low Level Format the drive, then partition and format the drive.
That should clean the drive, and it should be fine, unless there is something physically wrong with the drive.
Regards, Chris
by otiss
by frobo
Hi,
the following is only a guess since i doesn?t know which kind of a PC you have.
Year?s ago the HHD technologie was at it?s beginning and we teks had to know all about a HD to install it in a PC, like number of Heads, cylnders and a lot more.The BIOS developer found that it would be best to create a List of common HDD?s with all this paramaters, so we had only to chose one number for the HD and it params. Unlikly could it be that you have chosen a number like 17 or 22 for your HDD, these parm is for an very old Hdd. Try if you can chose autodetect for your HDD setings in your PC-BIOS. Normaly if you press CTRL+Esc at the POST you should go in the CMOS-Setup screen of your PC and check the HDD settings their.
Regards
Frobo
by otiss
by otiss
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending