Windows Forum
I have a regular IDE Western Digital Hard drive that has a capacity of 250 GB. I have installed in as a slave in my XP Pro system. I see the drive but only set up to 128 GB? In the CMOS I see the drive and it shows that it is 250 GB. I tought Windows XP could see up to a teribyte ?
Any ideas ?
by softcorp.us
Hello!
You need to install SP1 (Service Pack 1) in order to use a drive larger than 128GB. Install at least SP1 and Windows XP will see the entire drive.
SP1 Link:
http://www.microsoft.com/windowsxp/downloads/updates/sp1/default.mspx
Explanation: How to enable 48-bit Logical Block Addressing support for ATAPI disk drives in Windows XP
http://support.microsoft.com/?kbid=303013
-----Steve Jackson
CEO/CSA
Software Corporation (Softcorp)
http://www.softcorp.us/probono
Pro Bono Software free for personal use
by nhoek
Poster rated this answer.
by nhoek
This discussion is closed to new replies.
Sort by Trending