Discussion Locked

Hard Drives

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I need to connect a second hard drive to my PC.
I connected the IDE lead and power supply but cannot access the drive?
I have rebooted and windows does not even recognise it is there?
HELP.

3 replies

by kima

- Check the jumper in both hard drives, try not specifying whether it is master or slave, just leave it for automatic detection
- make sure the cables are connected correctly at both ends the motherboard and the 2 HD's
- Check the manufacturers instructions for your motherboard and hard drive to see if they are supported (or support Xple HD)
- Chk BIOS, SETUP

If that doesn't work try using EZ drive if it is a Western HD or get the appropriate utilities for the HD you have by going to their website and downloading. They always offer useful tools to troubleshoot their HD.

by grayceworkss

first you must make sure the jumpers are correct. for instance, a western digital drive set default will start as master with or without a slave drive. but set as MASTER, will only start with a slave drive on the same cable, and set as slave will start as slave.

second, you must make sure that the bios sees the drive. go into the bios settings, and if possible, set it to autoconfigure, otherwise have it go through and specify the settings.

third, you must partition the drive before windows will see it. use fdisk to partition it. make sure you select the correct drive though, or you could accidentally fdisk your existing drive!

once fdisk'd, windows should see it but will not be able to access it until the partition is formatted.formatting goes much quicker in windows than the dos format.

hope this helps

by jackzero

use disk administrator if using windows2000, NT or XP. make sure the jumper setting is correct and it is NOT the primary master

This discussion is closed to new replies.