Discussion Locked

Hardware error

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I tried pinging the router but it gave me a hardware failure error; however, I could ping the local PC and I could use a loopback but no other and it only does this on one particular PC...help!

9 replies

by dmiles

Check the NIC card by changing it out and see if you have the cables connected properly,reinstalling the driver may help,by updating it

by mckaytech

I'd say that you should take the error message literally and try swapping out the NIC card.

paul

by rmm

There's a couple of different things that you can try first before replacing the NIC. Remove everything under Networking under the Control Panel and then reboot and let Windows re-install everything and just make sure you have the lastest drivers for your NIC. Or run diag tools on it if that's possible. Or check for the lights on the side of the NIC. Or plug in a known good pc in it's place to see if something is wrong with the wall socket. If none of that works, replace the NIC.

by bock2000

A couple of things to try:

Try manually uninstalling tcp/ip as well. Removing everthing from Network Properties and reinstalling will not necessarily grab new files, so check Microsoft's website for instructions on how to manually remove tcp/ip.(if you can't find it email me and I can locate it and send you a link)
After uninstalling reboot the computer and it should redetect and ask for the files again.

If you use Internet Explorer, reinstall it. We had a similiar problem with a machine that this resolved the problem.

Also if you are using dhcp try entering one instead, this has also resolved some of our similiar problems.

This discussion is closed to new replies.