Question Locked

HDD is not detecting

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i got a this message "boot disk faliure plese insert....."

i m facing this problem for last one year. then i tried to short-out this problem by moving the ram to the next slot then i start the computer, it worked and few month later again i receive this message and nowdays i always recieve this message whenever my pc hang on and i restart my pc.

Please give me a proper soltion.

5 replies

by rob miners

the motherboard. I tried other PSU CPU RAM Cards
same problem. lasted 3 years though.

by pamcse

I am not sure why you are moving the RAM around when the error states 'boot disk failure'!! This error means computer could not find an operating system. RAM error *usually* causes BIOS beep tones.

Will computer boot to bootable floppy (Win 98 boot floppy)? If yes, then I suspect your hard drive is failing/has failed!!

Is BIOS set to look for HDD first? Set it to look for floppy first and do above test.

When computer boots, is the hard drive listed (IDE devices) in BIOS screen? If BIOS doesn't see it, bootup will fail.

How long has it been since you ran 'error checking' on hard drive? Can you swap the hard drive... just to see if it will start to load the operating system?

Start looking at HDD issues... not RAM.

Good luck...

by amit.more

i belive that there no proper os installation as there might be some problem with the hard drive that the boot sector might be missing doing os reinstallation or repair will not work so u will have to fromat the whole hard drive means do DEBUGand then do os reinstallation

by mjd420nova

Check the CMOS battery, they will give the strangest problems when they go dead. Could be the unit is working with default BIOS and won't hold any changes until the battery gets replaced. A reseating of all chips and plugin boards and connectors wouldn't hurt to eliminate intermittents.

This discussion is closed to new replies.