Discussion Locked

Help! CD ROM stopped working

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have recently installed XP, and low and behold, I have problems! I have been using my cd rom for the last couple of wks and was working fine - until the other day, it stopped working. The drivers seem to be fine and there are no conflicts in the device manager. It is being picked up as a drive, but won't read anything....... any answers?

6 replies

by thechas

The easiest thing to try, is to remove the drive and IDE controller from device manager, and let XP find them again and re-install the drivers when you re-boot.

The next step would be to see if the motherboard or chipset mfg has an updated XP driver.

I have seen Windows Update send an incorrect driver file.
I have also seen software installs "blow-away" the IDE driver.

Chas

by c_cee

Unfortunately, I have found that the cd rom is dead - have installed an old one, and is working fine, thanks for the help anyway!

by c_cee

Thanks for the help, but no go. It reinstalled exactly the same thing, and my problem is I think I have the right drivers - if this is the problem - but I have it on a cd which I cannot read!

by dcosgrove

In the hardware manager do you see ide conroller, primary and secondary conrollers? You need to see all three. Otherwise, it's likely the drive itself. Does the light blink when you insert a CD or does it just close the tray and sit there?

by c_cee

Unfortunately, I have found that the cd rom is dead - have installed an old one, and is working fine, thanks for the help anyway!

This discussion is closed to new replies.