Discussion Locked

Help with NT PROXY

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I currently have a PDC, BDC and Proxy (Stand alone) . All with NT4.0 with Service Pack 6. When the BDC is Logged off the network or is unplugged form the network, no one is able to communicate with the Proxy server. The PDC is unable to communicate with the Proxy. The PDC and Proxy are plugged into the same hub/switch and the BDC is located in a different room. When the BDC is unplugged everyone one can still log on and communicate with other computers except the Proxy. Any suggestions?

4 replies

by ebob

I would have a look to make sure that all of the systems use the BDC as their primary WINS resolution and the PDC as secondary. If this is already the case, experiment by changing those around. (I have seen where the clients do not "play well" with (shudder) WINS.)

by philldmc

Proxy = 10.0.0.1
PDC = 10.0.0.2
BDC = 10.0.0.3

Currently clients are not using WINS. And the PDC is the DCHP server.

This discussion is closed to new replies.