Discussion Locked

Hexadecimal

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

As I am trying to create a driver in the config.sys for an exteranl non-plug-n-play device, I need to know please the hexadecimal notation equivelant to the LPT1 port. This was requested by the installation instructions.
Thank you very much

5 replies

by mphoffar

Normally this is 0378...but it depentd on how the system was configured. The post screen should tell you this on startup

Mark

by syscokid

Answer #1 is correct. If the POST screen goes by too fast, you can also check it by going to Control Panel -> System -> Device Manager -> Ports (COM & LPT). Go to LPT1, click on properties, look on the Resource tab. It'll say Input/Output Range: 0378-037F or somesuch.

This discussion is closed to new replies.