Question Locked

How can I get XP to recognize a removable FAT-formatted drive?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a FAT-xx formatted SmartMedia card with very valuable data on it and my card reader won't recognize it since I reinstalled XP. It says that it's not formatted and unformatable. What do I need to do to make the card readable without formatting it?

5 replies

by sgt_shultz

there must be a utility for converting your partition. I bet partition magic would do it. otherwise, i'd look for a copy of windows 98se to install as dual boot (might be problematic, better be ready for a hassle)- better yet put 98 on an old hard drive and temporarily remove my xp boot drive. then i'd copy the data off, reformat the drive as fat32 and copy it back. then xp should be able to read it.
probably others have an easier way...

by sgt_shultz

check this out:
How to convert a FAT16 volume or a FAT32 volume to an NTFS file system in Windows XP
http://support.microsoft.com/kb/307881/en-us

a snippet:
How to convert a FAT volume or a FAT32 volume to NTFS
Note Although the chance of corruption or data loss during the conversion is minimal, we recommend that you perform a backup of the data on the volume that you want to convert before you start the conversion.

To convert an existing FAT or FAT32 volume to NTFS, follow these steps: 1. Click Start, point to All Programs, point to Accessories, and then click Command Prompt.
2. At the command prompt, type the following, where drive letter is the drive that you want to convert:
convert drive letter: /fs:ntfs
For example, type the following command to convert drive E to NTFS:
convert e: /fs:ntfs
Note If the operating system is on the drive that you are converting, you will be prompted to schedule the task when you restart the computer because the conversion cannot be completed while the operating system is running. When you are prompted, click YES.
3. When you receive the following message at the command prompt, type the volume label of the drive that you are converting, and then press ENTER:
The type of the file system is FAT.
Enter the current volume label for drive drive letter
4. When the conversion to NTFS is complete, you receive the following message at the command prompt:
Conversion complete
5. Quit the command prompt.

by 1bn0

And my usb drives.

The problem may be an incompatability or driver issue with your smart card reader. You will get the same issue moving cards between MP3 players with card slots built in. A card will work in one player but not in another. Reformat in the "non-working" reader and it works fine.

I get the same error occasionally with floppy disks. I also occasionally get the same error with my USB SDcard reader. I leave the reader plugged in eject
the card and re-insert it and everything is fine.

Most card readers today are built as cheaply as possible. Theres not much to them anyway.

I would try the card in another reader equipped P.C. Don't give up try two or three.

by darksound_

I think I'll just have to invest in a newer card reader. Thanks guys

This discussion is closed to new replies.