Discussion Locked

how can I remove wan miniport adaptors

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Somehow I have managed to create corrupt Wan Miniport virtual adaptors which prevent me from using dial-up networking on my W2Kpro system but they cannot be uninstalled - the system says they are needed to boot up the computer. The device manager shows them as corrupt and I get PPP protocol errors when I try to dial up. How do I fix this???????

4 replies

by tech010

Try uninstalling your dial-up adaptor and removing TCP/IP and NetBeui. Next reboot and reinstall the adaptor and protocols this should fix it. If not, let me know; I believe you can also remove them from the registry but I'm not too sure off hand how to do this.

by t.hoare

Good try but I have already done it and it does not work. Removed all network components and physically removed the NIC and then rebooted but they're still there.

by joseph moore

Did you try booting into Safe Mode to remove the adaptor? I don't know if it will work, but it is worth a shot.

This discussion is closed to new replies.