Discussion Locked

How do I restore an NTFS file system?

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Recently we experienced a power outage that resulted in the unexpected shutdown of an NT 4.0 Server. When we rebooted the machine, the hard drive was recognized by Windows but the volume didn't contain a recognized file system. Is there any way torestore the drive to NTFS without formatting, as we don't want to lose the data (about 6 GB) on the drive. We were thinking of using a data recovery service, but they can be very expensive. If anyone has any ideas, please respond. Thanks

9 replies

by spiceman

If you have made a recovery disk by running rdisk.exe you can start a fresh install and when type of installation option comes up you need to select R for repair. This will give prompt you for recovery disk. Ensure you update all the operating system. This should leave your current file system intact and give you access to your data and programs. You should ensure you run the service pack you had before the crash.

If this does not work do a complete upgrade of your system by selecting upgrade for installation option. Then you will have access to your whole hard disk.

A useful utility if you are running Norton utitities already is the recovery disk from that program

Partition magic is also another utility that may help if the abovefail.

good luck

by dmiles

You may be able to use the Norton UtilityData Recovery by downloading it from the www.symantec.com,also try using the startup boot disk and boot to the last known good configuration,which would boot to the last known good configuration.

by kwflick

First off you didn't mention what drive it was that isn't recognized. I will assume from your question that it is a secondary drive since Windows (NT Server??) sees it. Since the OS sees it, but it says there is no rocognized file system on it thatmeans that it crashed(due to a power failure). You have the option of a data recovery service, or starting over by recreating all the data from scratch. Did you make backups of the data? If you did, replace the drive and restore the backup to thenew drive. If you didn't make backups then you are essentially screwed. Since this is a server you should invest in an uninteruptable power supply so this will not happen in the future. You should also do backups on a daily or an hourly basis if the data is critical.

by kwflick

First off you didn't mention what drive it was that isn't recognized. I will assume from your question that it is a secondary drive since Windows (NT Server??) sees it. Since the OS sees it, but it says there is no rocognized file system on it thatmeans that it crashed(due to a power failure). You have the option of a data recovery service, or starting over by recreating all the data from scratch. Did you make backups of the data? If you did, replace the drive and restore the backup to thenew drive. If you didn't make backups then you are essentially screwed. Since this is a server you should invest in an uninteruptable power supply so this will not happen in the future. You should also do backups on a daily or an hourly basis if the data is critical.

This discussion is closed to new replies.