Question Locked

How do I set up a panasonic FP-D355 copier up to work on network. Has NIC

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a printer but no drivers or manual. Trying to network it. Need help.

7 replies

by cg it

if it has a network card, it needs an address. manual will tell you how to configure the network card using the pad.

by fpahl60

I have looked and can not find a manual for this copier. Wonder if there is one out there that would be shared. At least the section on setting up the NIC. I think I read somewhere that there was a CD to help install.

Thank you for your help.

by fpahl60

I did not find my manual but the drivers were very helpful.

Thank you very much.

by johnk98125

In order to give the FP-D355 a network address, one needs to start from the user preset panel.
1) press the User Preset Key, this will get you to a screen that asks for the next step. Choices are GENERAL FUNCTIONS, COPIER FUNCTIONS, etc.
2) Choose GENERAL FUNCTIONS.
3) Cycle to screen 2/2, and then select Key operator mode.
4) Key in the 3 digit key operator ID code. Default is 000. [Hope that works for you.]
5) Cycle to screen 5/9. Select TCP/IP address and modify this field to the desired static IP address of your choice. Also, set the subnet mask and gateway.

That will get you a proper IP address for the FP-D355. My problem is that there doesn't seem to be any updated drivers (i.e. Windows 7, 64 bit) for this old printer. Anyone out there with a generic netwrok printer installation solution?

This discussion is closed to new replies.