Discussion Locked

How do I setup a print server

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I want to move my printer off of my peer-to-peer network to my domain network. Does anyone know where I can get some step by step instructions to setup one of my NT servers as a Print server for my HP printers?
Do I need to install some kind of s.w. like Jetadmin ?

6 replies

by tbui

Go to your Server and go to http://productfinder.support.hp.com/
search for jetadmin for your printer then select NT, Download and install, The software will walk you throught and config the printer, You must manual config the IP address on your printer and make sure you can ping the printer before the jetadmin install.

by vagab0nd

It's better to use DLC with HP printers and you don't need JetAdmin. To setup HP printer you'll need JetDirect card installed in printer. The you'll need to get MAC address of this card (to do this simply print config page of your printer). Then do the following:

1. Install the DLC protocol on server by clicking the Protocol tab in the Control Panel Network tool. Restart server.

2. Click the Start button, point to Settings, and then click Printers.

3. Double-click the Add Printer icon. Accept the default setting which is "My Computer" by clicking Next. You are now in the Add Printer wizard box.

4. Click Add Port.

5. In the Available Printer Ports list, select the Hewlett-Packard Network Port, and then click New Port.6. In the Name box, type in the name that you want for this printer. Under the Name, type in the card MAC address if it does not appear in the list.

7. Click OK, then close. You are now at the printer Wizard box again.

8. Select the printer type, and then click next. Provide a path to drivers if needed. Type in the name of the printer, and then share the printer.

9. Print a test page to verify the new drivers' status.

10. Set proper permissions through Properties->Permissions.You are done! Good luck.

This discussion is closed to new replies.