When it isn't clear what layer the problem is at (from the symptoms) I try to start in the middle and go up or down as the initial check indicates. Using the example of the networked printer problem in a remote building, I start off knowing that the building is probably on-line because failure of a bridgehead switch generates audible alarms from our network monitoring software.
Our network printers have static addresses and I can pull up a spreadsheet with all the IP Addresses tied to building and room number. If I enter the IP address in my browser and get a web admin screen showing printer condition/status that confirms all the lower levels are good and I may see that the printer is out of paper or has low toner. If I don't see any obvious problems, I'll check the print server queues with a Remote Desktop connection to see if more than one queue is having problems. That might call for restarting Print Services to see if that clears a bigger problem than reported, or maybe indicates that a hung print job needs to be restarted or deleted on the one queue.
If I can't get there with the web browser, it is a lower level problem that I'd tackle by trying a ping from the command prompt. If I can ping, I'd try to telnet to the IP address of the NIC to see if it is operating.
If I don't get a good ping, I'd (no groans, now) walk over to the Apple Admin workstation and use Apple Remote Desktop to get a list of all the active IP addresses on the appropriate VLAN and check to see which printers are on (from our designated printer range). If the IP isn't active, I'll probably have to walk over to see if the printer is turned off, the local circuit breaker has tripped, the data cable is unplugged, or try to print a configuration page to see if the NIC has lost its IP address.
The Layer 0 problems require a bit more work, like the call from a secretary that her computer wasn't booting up. When she was asked for the State Tag number (our asset accounting tag) of the system she said that she couldn't find it because the room lights were off. The electrical service panel for about a quarter of the building had its main breaker trip, but her problem was that the computer wouldn't boot.