Discussion Locked

How much can my NT server do ?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a HP LC2000 which is a Intel 866 mhz 256 ram, scsi raid 5 hot-swap, redundant nic, power & scsi controller. NT 4.0 computer for 25 users.

I use it as my PDC, it also has a internal post office Microsoft Mail and is sharing a folder of about 9gb (usually running about 75% full)

I'm also using the DLC protocol for print server for one HP color plotter

It's setup to do redundancy of my login scripts to my BDC

The computer works just fine and also does archives for me at night.

Question ?

I am thinking of moving more printers over onto this server

1 HP LaserJet 5000 (mono)
1 HP LaserJet 2100 (mono)
1 HP Plotter 600 (mono)
1 HP DeskJet 1120C (Color)

Would this be to much of a load on this computer ?Any suggestions or feed back would be greatly appreciated...

5 replies

by kthurston

Honestly? Unless you're printing to every printer at the same time all day long for 400 years, I don't think it will hurt. I have a Pentium II 300 with 64 MB ram and 2 scsi hard drives running about 25 printers and it doesn't even flinch. Printers are a minimal drain on the system resources. You will be fine.

by some guy in seattle

I'm not too familiar with the exact properties of the printers in question but I do have a few suggestions.

The first is to install the performance monitor on your machine to build a baseline for typical performance throughout the day. There's anumber of graphs there that can tell you what resources may or may not be maxing out at any time. After running this for a couple of days or weeks you can have a good indication of peak points of activity for your server. After determining this, you can make a good guess as to how it may be able to handle the extra load.

Another suggestion is to add RAM. As your resource use goes up, it's always a good preventative measure.

A third suggestion: evaluate the onboard RAM of each printer.If they are upgradeable, then add RAM to them because the sooner the server can spool the print jobs to them, the quicker the server's resources can be freed for other work.

Also, you can set up within the print manager the priority of users, printer, and print job resource priority. If you decide to go ahead, you can then apply more granular control of printing in order to keep this poor, tired, worn-out box :-) working more efficiently.

Hope that helps -

This discussion is closed to new replies.