Discussion Locked

How to add another CPU on a NT4.0 Server

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a perfectly working NT4 Server installation and I want to add another CPU WITHOUT NT reinstallation. The motherboard supports multiple CPUs of course.

My problem is that NT doesn't recognize the new CPU. BIOS recognizes it, but NT doesn't.

9 replies

by dc1

You can use UPTomp from the resource kit nut it is much easier to check with the server vendor (Dell, Compaq, IBM) to see if they have a utility to update the HAL to multiprocessor. Much easier route than using uptomp.

by gregory w. smith

UPTOMP works fine; do be sure to reapply your current Service Pack before reboot, or you will have an unbootable system.

by mkfellows

Service Pack Application can effect MPS upgrade
1. Make, verify, and test a full system backup; update the ERD.
2. Bring down the server.
3. Install the new processor.
4. Restart the server. Remove the Read-Only attribute from %systemroot%\repair\setup.log and make a backup copy of it.
Edit as follows:
For Windows NT 4.0:
\<%systemroot%>\system32\ntoskrnl.exe = ?NTKRNLMP.EXE?,?e76ab?
\<%systemroot%>\system32\kernel32.dll = ?KERNEL32.DLL?,?5b7f8?
\<%systemroot%>\system32\winsrv.dll = ?WINSRV.DLL?,?37b4e?
\<%systemroot%>\system32\ntdll.dll = ?NTDLL.DLL?,?59c19?
\<%systemroot%>\system32\win32k.sys = ?WIN32K.SYS?,?132603?
\<%systemroot%>\system32\hal.dll = (see chart below or refer to KB article Q156358 for other processors)
Processor Entry
MPS (Multiprocessor Specification) Multiprocessor PC* "HALMPS.DLL", "1a01c"
Compaq SystemPro (or compatible) Multiprocessor "HALSP.DLL", "0f337"
* Replaces HALAPIC.DLL
For Windows NT 4.0 Terminal Server Edition:
\<%systemroot%>\system32\ntoskrnl.exe = ?NTKRNLMP.EXE?,?fe754?
\<%systemroot%>\system32\kernel32.dll = ?KERNEL32.DLL?,?700ee?
\<%systemroot%>\system32\winsrv.dll = ?WINSRV.DLL?,?3e526?
\<%systemroot%>\system32\ntdll.dll = ?NTDLL.DLL?,?62b31?
\<%systemroot%>\system32\win32k.sys = ?WIN32K.SYS?,?140e95?
\<%systemroot%>\system32\hal.dll = (see chart below or refer to KB article Q156358 for other processors)
Processor Entry
MPS (Multiprocessor Specification) Multiprocessor PC* "HALMPS.DLL", "1a062"
Compaq SystemPro (or compatible) Multiprocessor "HALSP.DLL", "15a34"
* Replaces HALAPIC.DLL
5. Save the modified setup.log in \%systemroot%\repair.
6. Apply or re-apply the current Service Pack (Service Pack 4 or greater).
7. Test. You can verify multiprocessor support by looking for ?Multiprocessor Kernel? on the ?Blue Screen of Life? during startup.

This discussion is closed to new replies.