Discussion Locked

HOW TO CONNECT NT4.0 WORK TO NT4.0 SERV

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
WE ARE TRYING TO FIGURE OUT HOW TO CONNECT 6 NT4.0 WORKSTATIONS TO A PDC IN THE SAME ROOM. THE WORKSTATIONS ARE ALREADY CONFIGURED, BUT I AM NOT SURE IF THEY ARE RIGHT. THE SAME THE THE PDC. IS THERE ANY WAY I CAN GET A STEP BY STEP INSTRUCTION ONHOW TO DO THIS FROM THE START?

2 replies

by stevencarter

Are you trying to do this with DHCP or Static IP Addresses? How are these workstations connected to the PDC? Are you using a hub or Co-AX cables?

by m.a.s. matrix

they are static and we are connected through a patch panel to the hub. the room has 12 pcs, 6 on each side. morning class is setting up server on one of the workstations and evening is doing the same. our server is going to have 5 workstations connected to it. if you logon to the workgroup, you can see everything, but we cannot logon to the domain. it is saying that they domain can not be found and it is not accesable.

This discussion is closed to new replies.