9 replies
by drew84 Accepted solution
by seanferd Accepted solution
Reboot.
Shutdown.
Reconnect drive.
Reboot.
[i]still cant fix it with solutions[/i]
We don't know what these were, so perhaps you could let us know up front, that we may avoid repeating solutions that have not helped.
by drew84 Accepted solution
by robo_dev Accepted solution
Thus if it's a Windows problem, this will fix it.
In order to test the drive, power off the computer and put in a bootable CD or DVD such as a Windows install disk, or a Linux Live distribution. If your PC can boot from the drive, then it's working.
by drew84 Accepted solution
by databaseben Accepted solution
sometimes, the dvd software becomes corrupted or incompatible as a result of time and or microsoft updates to the o.s.
my suggestion is to remove all software for the dvd, like nero and others. after going through the uninstall scenario, open the explorer and delete any folders for the dvd, like the nero folder and or others.
then uninstall the dvd drivers.
then power down the system and disconnect the dvd from the power supply and motherboard.
then power up the machine and after windows and the hard drive settles down, run a check disk, defrag, delete the all files in the temporary folder, and then a registry cleaner like "wise registry cleaner" from cnet.com
then reboot windows and allow it and the hd to settle down again.
now that the file system has been tuned up, the next step is to re-connect the dvd.
so power down the machine, reconnect the dvd wiring and restart windows.
then see if windows goes through the "found new hard ware" process.
if windows doesnt see the new hardware, then the dvd could be faulty.
to check it out, find or borrow or make a bootable dvd and see if the machine will boot up with it at start up time, ie before windows initializes.
if the machine doesn't boot up, then the dvd player is faulty.
at this point, if it is faulty, then maybe the dvd laser head is dirty (which can be cleaned) or the mechanism has turned to dust.
if however, the machine does boot up with the dvd player, then go to the dvd players website and see it they have any patches or fixes available.
by seanferd Accepted solution
"and it only stoped working after i tyook the other dvd drive out"
Were they both on the same cable? Was the current drive the Slave? If so:
Set the jumpers on the drive to Master*, and reconnect the data cable using the other connector.
*You will very likely need to remove the drive to do this. If there are no markings indicating which jumpers are master/slave/cs, refer to the vendor documentation for your exact model and revision drive.
by kevin.busby Accepted solution
by drew84 Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending