Question Locked

How to install and run windows xp on usb flash drive

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The title says it all. I might just have looked at every article on the topic but theres always something that goes wrong. My drive is bootable. Windows xp detects it in setup. It just won't install. I got an error once when installing. something about ntdlr or something. then it wouldn't install. Does anybody know how to install windows xp on usb flash drive? I got a SimpleFlash 2.0 usb flash drive by SimpleTech by the way if that helps any.

13 replies

by older mycroft

Who's [b]actually[/b] got a working one of these beasties.

Then I'll just steal it!!! :D :D :D

by lamentofking

Will I be able to go through 'My Computer' on the ufd and go through my hd to my windows partition and access my files? Can I like install something from the ufd to the hd and run it too?

by older mycroft

Were - in essence - supposed to be self-contained.

A bit like running a Virtual Box, only sort of less-virtual if you will.

by cg it

you don't install it from the Flash drive to the HDD. For that you need Ghost and an bootable image file. Depending upon the size of the image file, you might need a USB CD/DVD drive [and those drivers on the bootable flash drive].

If this is an IDE or SATA drive, BartPE works great for a bootable flash drive with Ghost [again just make sure you have the CD/DVD Rom drivers loaded]to initialize HDDs and install bootable images onto HDDs

by lamentofking

When I try to boot from it, te comp bypassed it and went to the hd (the only other bootable device that was there) So I removed the hd and left teh usb as the only device (along with the cd drive which had no disc in it)I booted the comp and it said "no bootable devices found" does this mean my ufd is not bootable or did i do something wrong. i followed the instructions.

by rob miners

instructions may have been overlooked. The Simple Flash 2.0 usb flash drive has to be prepared before it can be booted from. You will have to create a Primary Partition and make it Active. Format it as FAT32.

HP has a tool to do this.

HP Drive Key Boot Utility

http://tinyurl.com/2zcd68

by cg it

also, the motherboard has to be able to boot to USB. If it doesn't have the capability to boot to USB then your doing a lot of work for nothing.

by rob miners

I really hope that the poster has checked the BIOS. ;-)

This discussion is closed to new replies.