Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Posted previously about Raid 0 setup with two drives failing. I was wondering is there a way to determine which drive of the two is the one that failed? Would need to know so can replace the bad one instead of buying two more.
3 replies
by malikjaru Accepted solution
Clarifications
by scott_heath Accepted solution
Making sure S.M.A.R.T. is enabled in the BIOS, see if it detects a bad drive. If you are 100% sure data is lost, put them both in another system, format them and run chdsk on them. Download the software from the HD manufacturer that checks the disks for failures.
BTW, What makes you think it's a HW failure and not a corrupt RAID config or parttion?
by malikjaru Accepted solution
I just spoke to him and he said when he tried to boot up computer, message came on saying error with disk array, then later message was "no operating system found". Hope this helps. I don't know much about Raid usage so glad you can help.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies