Discussion Locked

How you can you know a dead Mainboard?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have socket 7 Motherboard that many of are components are ok but if i switch on only i have see black on monitor without any thing whats wrong? is it possible that motherboard is right off? and I have Dell 4/33 that only know hard disk with space not more than 512Mb if I put hard disk with more than 600Mb i fall in problem that system are not start and bring me message like 'Hard disk error' and if I change jumper i was get 'Missing operating system' whats wrong on it?

6 replies

by stngfan1

First Problem: Take out all the cards and try to boot the PC with Just the video card installed. Disconnect the HDD and Floppy drive and try to boot too. If everthing is disconnected and you still cant see anything then the Main board is bad. Alsotry a different power supply.

Second Problem:When you add the new HDD check the bios to see if it sees the new drive, make sure the setting are correct.

TM

by wjohn56191

I had this same exact problem with a 1995 gateway. After a talk with Procom (actually its a Seagate hard drive) it appears that the bios is so old that it cannot accept this new 10 gig hard drive. They recomended that I purchase an Ultra DMA Controller Number PR U33-PCI for about 115.00 The tech indicated that the reason that I was obtaining these same errors is that my old computers bios cannot resolve this large drive. Also when I connected up the existing 1 gig hard drive it works ok but even if I slave the new 10 gig drive to the gateway computer it hangs up and just sits there.
I will attempt to obtain a bios upgrade and see if that will help.
Thanks
Warren

by lumumba

About Hard Disk all of yours you're answers are right i don't have any objection. Thank you all for Helping Me.
Regards,

This discussion is closed to new replies.