Discussion Locked

How you can you know a dead Mainboard?

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have socket 7 Motherboard that many of are components are ok but if i switch on only i have see black on monitor without any thing whats wrong? is it possible that motherboard is right off? and I have Dell 4/33 that only know hard disk with space not more than 512Mb if I put hard disk with more than 600Mb i fall in problem that system are not start and bring me message like 'Hard disk error' and if I change jumper i was get 'Missing operating system' whats wrong on it?

11 replies

by ryan147

Well from my experience, when I only see the black screen, it has been the board, not saying it is, but a good possibility. And if I understand correctly the system will boot w/ a HDD under 600MB, but not over. You may want to check the manufacturer of the boards website and see if they have a bios update. Hope thats helps.

by cpmajor2002

I do not want to second question anyone. but it has been my experience, that if the system is getting power and you have nothing showing on your monitor but a black screen, that it is either the video card/controller or the monitor itself. try the monitor on a different computer, if it works, then it is the video card/controller.

by smltec

both other answers are baloney. If you are getting a screen at all you dont have a video card problem. you will need to boot to bios to see if hdd is recognized. If it is recognized, boot to a bootable floppy disk,change to c:\prompt and do a directory command. If you have files on the hdd then go back to the a:\ prompt and type sys c: this will put the system files back on the boot sector so the hdd will boot. If you cant go to the c:\ prompt, then the hdd will either have to be fdisked and formatted and reloaded or it is toast

hope this helps

by dave

Black screen:

if your monitor has an LED that changes from (say) orange to green when the video card fires up properly, that is a better indication of whats happening. If it doesn't go green, in my experience this could be due to:

dud or badly-seated memory
dud or badly-seated video card
BIOS settings enabling/disabling onboard video wrongly
wrong or faulty video connectors
faulty motherboard or CPU
faulty PSU

in approximately that order of likelihood

If you are used to the sounds and sequence of a normal boot-up routine (disks spinning up, floppy drive trying to boot, speaker beep etc) this can give you more clues.

-------------
Dell HD problem:

set BIOS to autodetect HD
boot from floppy disk
do a "DIR C:" tosee whats on it.

If no joy, either its not formatted or the auto-detect parameters are wrong - reset the BIOS to try all 3 modes by hand - LBA mode, Blockmode or normal and try again.

If its recognised but unformatted run FDISK.

Hard Diskerror usually means its not recognised by the BIOS in that mode (or the HDD is bust)

Missing Operating System usually means the disk is recognised and formatted but... wait for it.. you haven't installed an operating system. Boot from floppy and then do "SYS C:", or boot from floppy and run SETUP on a Windows CD, or boot from a LINUX floppy and do whatever.

If the HD size > 512MB is causing a problem, there may be a fix for old M/boards from the disk manufacturer (I used to have one from Western Digital that patched the boot sector - came with the HD), or you could FDISK it to have multiple partitions each less than 512MB.

good luck

by mlman

It appears that you are able to get this to boot, so that would eliminate the video card and RAM being mis-seated. Your system would just beep at you if either of these were in thier slots wrong. As far as not being able to boot with a HD larger than 512 Mb,I would recommend a BIOS upgrade. Visit your BIOS vendor's website for the latest and flash the BIOS following thier proceedures. Good Luck.

This discussion is closed to new replies.