Discussion Locked

HP LaserJet 2100TN Settings Issue

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an HP LaserJet 2100TN printer that was working fine for months. Yesterday all of a sudden documents queued to this printer, the settings changed to "Manual Feed with Pause" instead of "Auto Select" as what is shows on the configuration tab of the Printer Properties settings.

Looking through the problem it seems that the printer looks for paper in Tray 1 (there are 3 trays) and if there is none it stops looking. When you put paper on Tray 1 it prints the first page then pause until you press the GO button on the printer, does it for each page.

Check all printer settings and document settings but the "Source in" setting is set to "Auto Select".

Uninstall the printer completelyt and created the printer on another server creating new JetDirect Port and installing the printer driver and software. Still with no luck...

Turned printer off and turned it back on even re-boot both servers, still no go...

Can anybody give me any ideas on what more I can do to fix this problem?

Thanks for your help.

6 replies

by robert schommer

From either the console of the printer or from JetAdmin, check the default tray setting. I just bet you will find that the printer itself is set with Tray 1 being default.

by shanghai sam

As you can see from my post I did checked the printer properties - document settings and it is set to "Auto Select".

Anymore ideas???

by jahaja

I would consider resetting the printer to factory default (on printer panel) and then do the settings from an updated driver downloaded from HP support page.

Jan

by shanghai sam

I actually uninstall the printer software from one server and install it on another server with default settings or factory default, without any luck.

Tried downloading the latest driver from HP and installing it, still no go.

Thanks for the response.

by rynzeski

I found the answer...

to get rid of changes to the default settings you need to do a COLD RESET.

Turn the printer on while you hold down the reset button for a few seconds.

This discussion is closed to new replies.