Discussion Locked

HP P4 2.2GHz CPU Fan failure

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Has anyone seen a one time halt when booting with WinXP where the message said that there was a CPU Fan Failure and to replace the fan immediately. Then no halt after rebooting and not replacing the fan. And none since. Is this an XP thing?

7 replies

by thechas

I have seen the BIOS fan monitor on a motherboard give a false failure warning on a re-boot.

Since I have my BIOS settings set to beep on hardware monitor errors, I always catch the problem, and shut down before XP gets a chance to boot.

I suspect that you have a similar situation, and a hardware monitor program that HP pre-installed on the PC is what is giving you the warning.

Of course, if the fan did stop, by the time you got the notice, the CPU would be toast.

Chas

by admin-stuart

It also sounds like the fan may have been in a position to catch on a wire or ribbon cable on that one occasion when you received the warning. This could be due to moving the PC some way.

by bonfire

the P4 has heat management... when it gets hot, it gets slower... that all that is to it...
it will just slow down so much that it is stable...

you can run it with passive cooler, and it will be ok... just a lot slower

This discussion is closed to new replies.