Discussion Locked

I can no longer log onto 4.0 NT Server

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just installed a DSL modem onto my home network and for some reason I can no longer log onto my server.

The set up is as follows:
Server = NT 4.0 with it's own IP etc for DSL.
Workstations = Win98 with IP for DSL. They all connect to a 5 port hub.

I can ping the server but when I try to log on it says that there is no domain available for validating my password. I was able to log onto the server before setting up the DSL anc configuring the new IP addresses.

Any suggestions?

3 replies

by bparnes

From what you've described, it looks like you have one NIC in your NT server but you are trying to connect it to two different networks. That's not good style. What you want to do is put a second NIC into the server. One of the NICs is configured toconnect the server to the Internet via DSL, while the other NIC is configured to connect the server to the LAN. That way, all the other computers on the LAN can connect to the server and communicate with it properly, without the Internet getting in the way.

by vancowboy

That is what I thought. Now the question that I have is will the PC's still be able to route through the server to the NIC that is using the DSL modem or do I have to go out and buy a router? (Ideally I want all 3 w/s and the server to use the oneDSL modem).

by zuidema

You can enable IP forwarding in the Routing tab from the TCP/IP Protocol properties screen (network properties/Protocols).
but this can only be done if you have valid IP addresses for al network interfaces.
If you use private ip ranges on your internal network you should install a NAT gateway or a proxy server to enable clients on your internal network to access resources on the internet.

This discussion is closed to new replies.